Boat type: sailing yacht
Boat name: Bayfield cutter
Boat length: 8.83m / 26.9ft
Price: $12000
Country: USA
Location: Florida, Jacksonville
Contact with seller by phone: 9045353318
Bayfield cutter 88.3 description- Bottom: VC 17 Epoxy, Interlux
- Hatches: 3 opening, 2 piece companion way, sliding hatch cover
- Lifelines: SS stanchions, upper and lower lifelines with gate supports
- Pulpits: SS double railed bow and stern
- Trim: Teak throughout
- Sole: teak and ash
- Lockers: Cockpit (large) with hinged cover; Bow Locker
- Compass: Galaxy, Lighted
- Ports: 9, 8 Beckson opening with screens (all lenses replaced) , 3 ports replaced (2013)
- Bilge Pump: Manual, Whale Type (cockpit)
- Deck structure made in separate water proof compartments. M: 50 deck designed for very rough seas with maximum protection for the crew and gears, it’s maximum heeling angle is 151°. All riggings can be used as “hands on Deck” or directly from the cockpit. Aluminum low profile ‘rolled edge’ bulwark with stainless steel mooring cleats. Two stainless steel pulpits one each on port and starboard side of the mast for safety when working at the mast.
- The hull is a water cut, inside-outside, welded Cartel Aluminum. Hull color dark Blue, deck covered with white anti: slip protection on original aluminum. Cockpit trimmed by antireflection white color on the side walls and teak wood inside the cockpit walking and seating areas laid with black caulking. The stern design incorporates a bathing platform trimmed with teak slats and teak slats stainless steel steps and handle for access from the stern deck.
- Fully protected skeg: hung hydraulic rudder with an additional custom made Windpilot .
- West Wight Potter 15 : New Old Stock. One owner boat, purchased new from International Marine in Inglewood, CA, this boat has never been in the water and has always been in the garage. Fully outfitted with many upgrades including galvanized Calkins trailer and Yamaha 4 HP outboard motor. The Trailer has a 2" ball hitch, and the tires are ST175/80D13B 13 x 4.5. Overall height of sailboat on trailer is 6'5". Overall length is 17'6" from hitch including motor. Overall width is 6'0".
- Locker: Hanging cedar locker
- Galley: SS steel sink, fresh water/lake water pumps. Force 10 2 burner stove and oven, gimballed and fiddled, corion fitted to stove for extra counter space, silverware dividers in drawer, storage cabinets
- Nav. Station: Teak chart table w/ swing out chair
- Dinette: Fold down teak table
- Ice Box: Frigaboat Refridgeration System with digital control; 6 by 12 by 8 freezer section mounted in Ice Box
- Fresh Water: 30 Imp. Gallons, pressurized
- Hot water: 5 gallon tank, electric
- Fuel: 18 Imp.galllons diesel, Racor fuel/ water separator; Fuel shut off valve
- Prop : Folding, 2 blade, PSS shaft seal (2013) new cutlass bearing (2010)
Bayfield cutter 88.3 - Beam: 10 3
- Draft: 3 6
- Description: Very good boat needs some tlc, rarily have to pump bilge. Need to sell am leaving the country for a year or so can not keep it up. Canvass needs replacing, yanmar engine runs great. new alum diesel tank, bilge pump and water pump added
- Equipment: gps 3yrs old grill never been used, spinaker, 3 anchors, sails good for daysailing but not new Sorry to those whose got no response on prior ad but need to sell in next couple of months
Bayfield cutter 88.3 equipment- Halyards: Double braid Dacron Genoa #1, #2, Main, Spinnaker & Pole lift
- Spinnaker Poles: 1 aluminum, 1 carbon fiber, 1 whisker pole
- Sinks: Stainless steel in galley with hot and cold pressure mixing faucet. Stainless steel in head with hot and cold pressure water and shower attachment.
- Hot Water Heater: Raritan 6 gallon with heat exchanger, copper tubing and polyurethane on cold water system.
- Domestic Water Tanks (2): Stainless steel, approximately 100 gallons; 1 bow and 1 under cabin sole.
- With its traditional V-berth arrangement and selection of fine woods hand: crafted into the closets, berths and dovetailed drawers; the forward stateroom epitomizes the quality workmanship Bristol has built its reputation on. There is also separate access to a well appointed head with hot and cold pressure water and shower.
- E: mail for list of equipment
- float: off trailer (galvanized), 2HP Johnson engine, North sails and Quantum genoa, deck cover with skirts (always keep under cover!). Very little used in the past two seasons.
- FAb: All 120 LP Cabin Heat
- Xintix S: 2A Propane/CNG Sniffer & Gas Control
- Perkins 4: 108 with new injectors, fuel pump, Balmar regulator, wiring, and water pump.
- -Replaced: used Northsail main in good condition (2013)
- Run-Rigging: Enhanced for racing- Double braid Dacron: Genoa, BoomVang (Spinlock powervang adjustable boomvang), Mainsheet ( 3 block 8 to 1 purchase with 24 to 1 fine tuning control), , Topping lift, Spinlock line stoppers (6 6)
- Winches: Two speed, self tailing Lewmar 30CST (2) and 40 CST (2), 2 Harken 30 winches cabin top, winch handels (3), cockpit winch handle pockets (4)
- Furling: Harken split drum (for racing) dual track forestay
- Mainsail: (1) Doyle fully battened, two reefs, boom cover; (1) Doyle Mylar racing main with full battens and carbon fiber tape drive
- Lines: 4 docking lines, 2 spring lines
- Fenders: 4 large inflatable
- Spare parts: fan belt, impeller, oil filter, fuel filster, misc. SS hardware
- Spinnakers: 1.5 oz. heavy spinnaker, 7 oz. AP spinnaker, .5 oz light spinnaker
- Bimini : Custom made navy Sumbrella (2013)
- Cradle: Custer marine Cradle Rigid steel (6 pads)
- Anchors: 35# Plow, 300 ft 5/8 in Nylon, 10 ft chain, 50 ft trip line/buoy; 15# Bruce, 10 ft chain, 150 ft Ѕ in Nylon; 100 ft 3/8 in Nylon
- Safety equipment: flares, flare pistol and cartridges, lightning arrestor at top of mast
Another sailing yachts for sale in USA |
