Boat type: sailing yacht Boat name: Hunter H27 Boat length: 8.22m / 25ft Price: $50000 Country: USA Location: Maine, South Bristol Contact with seller by phone: (207) 644-1552
Hunter H27 description- 1980 22' Catalina swing keel, with roller: furling and 150 Genoa. 6HP Yamaha just rebuilt and new fuel tank. In water and ready to go.
- 2008 hunter 27; fin keel, diesel inboard, in: mast furling, head/shower, galley, pressure water H/C, VHF, GPS, St40 Knot/Depth, stereo. Very lightly used. Excellent condition.
- Ports: 9, 8 Beckson opening with screens (all lenses replaced) , 3 ports replaced (2013)
- Bottom: VC 17 Epoxy, Interlux
- Hatches: 3 opening, 2 piece companion way, sliding hatch cover
- Main sheet winch, traveler, and jib sheet winches are all within easy reach of the helm. All non: skid (no teak) decks, double bow and stern railings, and double lifelines provide secure passage around the decks. Seven hatches with custom Outland ridged covers, four dorade vents and eleven opening ports (Newfound Metals Stainless steel just installed 2015) provide ample light and ventilation below.
- 1994 Intermountain Boat Works #14624. Excellent condition. 2 sets of sails. Steel centerboard. This boat is very stable: ideal for family fun. It would make an excellent sailboat at camp or on the lake. It is easy to rig and even easier to sail. Great training boat.Used only two times the last two seasons. Mooring cover. Travel cover.Trailer included.
- esigner: Joubert / Nivelt
- Lifelines: SS stanchions, upper and lower lifelines with gate supports
- Pulpits: SS double railed bow and stern
- Trim: Teak throughout
- Sole: teak and ash
- Lockers: Cockpit (large) with hinged cover; Bow Locker
- Bilge Pump: Manual, Whale Type (cockpit)
- Compass: Galaxy, Lighted
- Nav. Station: Teak chart table w/ swing out chair
- Dinette: Fold down teak table
- Locker: Hanging cedar locker
- Galley: SS steel sink, fresh water/lake water pumps. Force 10 2 burner stove and oven, gimballed and fiddled, corion fitted to stove for extra counter space, silverware dividers in drawer, storage cabinets
- Ice Box: Frigaboat Refridgeration System with digital control; 6 by 12 by 8 freezer section mounted in Ice Box
- Fresh Water: 30 Imp. Gallons, pressurized
- Hot water: 5 gallon tank, electric
- Fuel: 18 Imp.galllons diesel, Racor fuel/ water separator; Fuel shut off valve
- Prop : Folding, 2 blade, PSS shaft seal (2013) new cutlass bearing (2010)
Hunter H27 - Beam: 9.8
- Draft: 3.6
- Equipment:
- Description: Complete J24 for sale. No trailer or outboard included. Is on trailer currently. Outboard is available. Deck kiwi gripped. updated front and main hatch. Lazarettes sealed off. Hardware has not been reinstalled after redoing deck. Main/Genoa/spinnaker all North Sails. Spin pole included. Bottom is barrier coated and VC17 applied. Yellow hull. All standing and running rigging in great shape. Upgraded traveler bar from Hall spars.
Hunter H27 equipment- Back: up manual FW pump
- Double top: loading refrigerator/freezer
- Built: in Stereos and satellite radio system
- Perkins 4: 108 FWC 50HP diesel (1800 hrs)
- Private guest cabin features a full across V: Bert, hanging locker, drawer, cabinet and outboard shelve storage and private entrance to the wet head.
- Mast was unstopped, prepped and re: painted with Awlgrip, the hardware was black powder coated, standing rigging was magnaflux tested and running rigging was renewed last 5 years. Chain Plates rebedded in 2015 and are exposed for easy access/inspection.
- Storm jib Hanks: well used bought second had does not look pretty
- • LINK: 10 power monitor
- Westerbeke 4: 108 diesel engine 2 fuel tanks totaling 55 gallons. Fresh water pressure system. New sails within the past 8 years, RF jib.
- • C: Map NT cards for Mexico (to PV) and South Pacific
- • Queen V: Berth with lockers and storage
- • Flex-o: o prop folding '04
- • Lectra: Scan waste treatment system '09
- • 10' Porta: Bote '08 – new oarlocks(2012) and oars (2011)
- • 6 : Jerry jugs for fuel
- 1 : 4 year old deep cycle batter , 1 Start battery in cabin both in good shape from panel
- Engine: yanmar 1 GM10: professionally replace all all piston rings and gaskets. in 2000. Did overheat, no seizing but needs new rings and honing from marina service
- Jib Hanks: used again some rust spots and worm but sails great no rips
- Spinnaker Poles: 1 aluminum, 1 carbon fiber, 1 whisker pole
- Halyards: Double braid Dacron Genoa #1, #2, Main, Spinnaker & Pole lift
- Run-Rigging: Enhanced for racing- Double braid Dacron: Genoa, BoomVang (Spinlock powervang adjustable boomvang), Mainsheet ( 3 block 8 to 1 purchase with 24 to 1 fine tuning control), , Topping lift, Spinlock line stoppers (6 6)
- Winches: Two speed, self tailing Lewmar 30CST (2) and 40 CST (2), 2 Harken 30 winches cabin top, winch handels (3), cockpit winch handle pockets (4)
- Furling: Harken split drum (for racing) dual track forestay
- Mainsail: (1) Doyle fully battened, two reefs, boom cover; (1) Doyle Mylar racing main with full battens and carbon fiber tape drive
- Lines: 4 docking lines, 2 spring lines
- Fenders: 4 large inflatable
- Spare parts: fan belt, impeller, oil filter, fuel filster, misc. SS hardware
- Spinnakers: 1.5 oz. heavy spinnaker, 7 oz. AP spinnaker, .5 oz light spinnaker
- Bimini : Custom made navy Sumbrella (2013)
- Cradle: Custer marine Cradle Rigid steel (6 pads)
- Anchors: 30lb Plow & 20lb Danforth anchors with new chain and 150’ of line.
- Gear: Bumpers, Flair Guns, Stainless Hardware Supply, Life Ring, Safety Harnesses, 2 Fire extinguishers, etc.
- Safety equipment: flares, flare pistol and cartridges, lightning arrestor at top of mast
- Outboard: 2003 Suzuki 4: Stroke, 15hp, electric start, long shaft, gas outboard with new 3 gallon tank.
- power : Two new deep cell marine 12V Batters, plus shore power.
|